| Board | Ordnance Factory |
| Category | State Govt |
| State | Madhya Pradesh |
| Post Date | 24 Jun 2026 |
| Col1 | Col2 |
|---|---|
| Organisation | Ordnance Factory Itarsi (Munitions India Limited) |
| Post | Tenure Based CPW (Chemical Process Worker) |
| Stage | Shortlist for Trade Test / Practical Test |
| Candidates Shortlisted | 828 |
| Reference Number | CBC 10201/12/0094/2526 (EN 61/72) |
| Notice Date | 22 June 2026 |
| Test Dates | 6 July - 11 July 2026 |
| Reporting Time | 8:30 AM |
| Test Start Time | 9:00 AM |
| Test Venue | Ayudh Nirmani Higher Secondary School, Ordnance Factory Estate, Itarsi |
This section gives the exact date-wise breakup of roll numbers so candidates can immediately check which day they are required to report for the test. The Trade Test / Practical Test will run across six days, from Monday, 6 July, to Saturday, 11 July 2026. Each day covers a specific block of roll numbers, so candidates should match their own roll number against the table below to confirm their reporting date.
This section covers when and where candidates must report, plus how to reach the venue if travelling from outside Itarsi. Candidates must arrive well before the test begins, since late entry is not guaranteed. The test will be conducted at a single designated venue within the Ordnance Factory Estate.
This section addresses a common concern among shortlisted candidates who are unsure whether they can still attend the test without an emailed admit card. Candidates who do not find a call letter or admit card in their email inbox can still appear for the Trade Test. They simply need to verify that their own name and father's name appear in the official shortlisted candidates' list, and then report on the scheduled date by following the standard reporting instructions.
Important: If a candidate's name appears on the list but they remain absent because they did not receive the email, Ordnance Factory Itarsi will not be held responsible. Every shortlisted candidate is strongly advised to personally check their name in the list rather than waiting for an email confirmation.
This section lists the mandatory documents candidates must carry, since incomplete documentation can affect participation in the test. Candidates must carry both identity proof and the original documents submitted earlier with their application. The following checklist applies to every shortlisted candidate:
Note: No boarding or lodging facility is available at or near the OFI Estate, so candidates travelling from outside Itarsi should plan same-day travel accordingly.
This section highlights critical conditions that affect a candidate's eligibility and participation, and should be read carefully before the test date.
This section gives quick context on the recruitment drive this shortlist belongs to, useful for candidates who are new to this notification. Ordnance Factory Itarsi had earlier released its Tenure Based CPW recruitment notification for 265 vacancies under the primary trade of AOCP (Attendant Operator Chemical Plant) and other specified feeder trades such as Fitter, Electrician, Machinist, and Turner. As per the official selection process, candidates are first shortlisted on the basis of their NAC marks against a trade-specific cut-off, then called for the Trade Test/Practical Test, after which a final merit list is prepared by combining both sets of marks before document verification and engagement.
Q1. When was the Ordnance Factory Itarsi CPW Merit List 2026 released?
The Ordnance Factory Itarsi CPW Merit List 2026 was released on 22 June 2026 on the official portal ddpdoo.gov.in.
Q2. How can I check Ordnance Factory Itarsi CPW Merit List 2026?
You can check your Ordnance Factory Itarsi CPW Merit List 2026 by visiting ddpdoo.gov.in, going to the Examinations → Result section, selecting the relevant Merit List link, and entering your roll number or registration number.
Q3. How many candidates have been shortlisted for the OFI CPW Trade Test 2026?
A total of 828 candidates have been shortlisted as provisionally eligible for the Trade Test/Practical Test.
Q4. When will the Ordnance Factory Itarsi Trade Test 2026 be conducted?
The Trade Test/Practical Test will be held from 6 July 2026 to 11 July 2026.
Q5. What is the reporting time for the OFI Trade Test?
Candidates must report by 8:30 AM. The test itself begins at 9:00 AM.